Duro Dyne Dyna-Tite 45 degree eyelets are manufactured of zinc plated cold rolled steel and swaged to the wire rope cable with a hydraulic press. 45 degree eyelet assemblies are available for installation with either a 1/4 inch or 3/8 inch fastener. They are also available both in 90 degree and straight assemblies, and as a kit with the appropriate cable lock

This item is the Duro Dyne Con-Lock Kit - part number 30166 - 4514-10WC3 (R030146). It contains a Con-Lock connector with 2 meters of a looped wire rope cable attached. Utilize the Duro Dyne Con-Lock connector for static working load limits up to 100 pounds. 

Suspension systems typically use threaded rod with washers and nuts to construct a support structure. Sizing, cutting and assembling the rods to the complementary parts and fastening them to an anchor point can be very time consuming. The Duro Dyne Con-Lock system is designed for the suspension of all static loads into all concrete types including slagged, cracked, slab and even hollow pot. The Con-Lock is designed to use a 1/4 inch or 6 mm drill bit. Then tapped into place with a standard hammer, No claw back of the anchor is needed for installation. There is no need for any other tools. 

With a working load limit of 100 pounds, or 50 Kilograms, the Duro Dyne Con-Lock can be used for most electrical installations. Looking for more possibilities? The Con-Lock is sold with the cable pre-attached in different lengths to solve almost any concrete project static load application.

Duro Dyne 1/4 Inch Eyelet Con-Lock Connector Specification Sheet